Digitalisation

Table 1 below gives the values and description of the codes that can be adjust, depending on the eggs that are placed inside.

If a condition set by a code is not met, then the controller signals to the user by flashing the LED "ALARM" . There is an option for an audible alarm..

Code	Function	Range	Note	Factory Default
P0	High temperature warning.	0 ~ 75℃	Warning only	38.7
P1	Exhaust temperature limit	0 ~ 75℃	Cooling exhaust starts	38.2
P2	Exhaustion temperature low limit	0 ~ 75℃	Stop cooling exhaust	38.0
P3	Main temperature up limit	0 ~ 75℃	Main heater stops heating	38.0
P4	Main temperature low limit	0 ~ 75℃	Main heater starts heating	37.9
P5	Aux temperature up limit	0 ~ 75℃	Aux heater stops heating	37.7
P6	Aux temperature low limit	0 ~ 75℃	Aux heater starts heating	37.5
P7	Low temperature warning point	0 ~ 75℃		37.2
P8	High humidity warning point	0 ~ 99%		70
P9	Humidity up limit	0 ~ 99%	Humidify load stops humidifying	60
Pb	Humidity low limit	0 ~ 99%	Humidify load starts humidifying	55
Pc	Exhaustion humidity up limit	0 ~ 99%	Start ventilation for de-humidifying	65
Pd	Exhaustion humidity low limit	0 ~ 99%	Stop de-humidifying ventilation	60
PE	Over wet exhaustion protection	0/1	0: disable; 1: enable	0
PP	Low humidity warning point	0 ~ 99%		50

Table 1

Code	Function	Range	Note	Factory Default
F1	Egg turn period	1 ~ 999 min		90
F2	Egg turn time	0 ~ 999 sec	0: no egg turning function	180
F3	Egg turn times	0 ~ 999 times	0: turn for ever	0
F4	Air exhausting period	1 ~ 999 min		120
F5	Air exhausting time	0 ~ 999 sec	0: no air exhausting	30

F6	Temperature calibration	-9.9 ~ 9.9℃		0.0
F7	Humidity calibration	-20 ~ 20%		0
F8	Illumination period	1 ~ 999 min		90
F9	Illumination time	0 ~ 999 min	0: no illuminating function	0
FF	Incubated days	0 ~ 99 day	Only clear operation	0

Date of last revision 24-May-21